Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterMr-Glass Door Installation: The West Palm Beach Owner’s Guide
Mr-Glass door installation in West Palm Beach typically runs $350-$900 installed for most residential models, and we stock the common Mr-Glass replacement hardware on our trucks so we can usually finish the job in one visit. Most owners call us after the door starts dragging on the track or the latch stops catching cleanly, which in South Florida humidity usually means worn rollers, a sagging hinge side, or a frame that has shifted out of square. This is not a brand-specific defect. It is what salt air, wet season moisture, and daily sun exposure do to any exterior door over a decade or two.
Key Takeaways
- We install and service Mr-Glass doors as an independent provider. We are not affiliated with the Mr-Glass brand.
- Most Mr-Glass door installation work in West Palm Beach is completed in a single visit.
- Free written estimates. Call (561) 264-1279.
Which Mr-Glass Models This Applies To
Mr-Glass has produced several door lines over the years, and the hardware is not always interchangeable between them. The most common units we service in West Palm Beach are the aluminum-frame impact-rated patio doors and the vinyl sliding glass doors used in mid-2000s to early-2010s construction. Some older Mr-Glass models used a proprietary roller carriage that is no longer manufactured, which is a compatibility gotcha to know before you buy a universal roller kit from a parts website. We match the roller width, wheel diameter, and axle pin length to the exact Mr-Glass series rather than guessing with an adjustable aftermarket part. The OEM rollers on those older series tend to wear flat on one side, which causes the door to jump the track when the bearing finally gives out. A quality aftermarket roller matched to the original spec usually outlasts the original, but only if the track is cleaned and aligned at the same time. On newer Mr-Glass impact-rated doors, the common failure point is the weatherstripping channel and the bottom sweep rather than the rollers, and those are quick, inexpensive fixes.
Signs Your Mr-Glass Door Installation Is Failing
- The door drags or takes two hands to move. This is almost always worn rollers or debris-clogged tracks. In West Palm Beach, sand and fine shell grit work their way into the track faster than inland homeowners would expect. Ignoring the drag will damage the track itself and turn a roller replacement into a track repair.
- The latch no longer lines up with the strike plate. When a Mr-Glass frame settles or the hinge side sags, the latching point drifts. Forcing the handle is what bends the latch bolt and cracks the faceplate. The fix is re-shimming and re-squareing the panel, not just filing the strike plate.
- Air and water leak through the threshold. The bottom sweep and threshold cap wear down on any sliding door, but Florida sun breaks down the rubber faster. If you can see daylight under the door at the corner, the sweep has failed and the threshold likely needs a new cap.
- The door rolls fine but rattles during wind gusts. Loose roller adjustments or a worn guide block let the panel float. During summer thunderstorms in West Palm Beach, that rattle is the panel slamming the frame. Left alone, it will chip the powder coat and loosen the glass.
- Condensation or haze has formed between the glass panes. That is a failed seal in the insulated glass unit, and with Mr-Glass doors it usually means replacing the glass pack rather than the whole door. If the door itself still operates cleanly, a glass-only replacement is the honest, lower-cost call.
Replacement Cost & What’s Included
Installed Mr-Glass door installation work in West Palm Beach falls into a few price bands. Here is what we quote, in writing, before we start:
- Roller replacement (both sides): $180-$350 depending on Mr-Glass series and roller type.
- Latch, lock, and strike plate alignment or replacement: $120-$280.
- Bottom sweep and threshold cap replacement: $95-$220.
- Full door removal, re-shim, re-square, and reinstall: $400-$700.
- Insulated glass pack replacement (seal failure): $500-$1,400 depending on glass size, tint, and impact rating.
The price difference between the low and high end of each band comes down to whether we are working on an older Mr-Glass series with obsolete hardware or a newer unit with parts we can source directly. Every quote includes parts, labor, cleanup, and the Done Right Promise. The Keystone Standard means both manufacturer warranty layers on any new part are registered in writing before our truck leaves your driveway, and the warranty durations are stated on your invoice, not buried in a pamphlet. We do not add surprise line items after the work starts. What we quote is what you pay.
DIY or Call Us?
You can safely check a few things on your own, and we encourage it. Vacuum the track, wipe down the rollers you can see, and look at the screws on the hinge and latch side to confirm nothing is visibly loose. You can also check the bottom sweep for brittleness by running a finger along the rubber, with the door open, not your hand under it. What we would not advise on a Mr-Glass door is pulling the panel off the track to replace rollers yourself. A sliding glass panel, especially an impact-rated one, is heavier than it looks, and once it is out of the track, it wants to fall forward. We have repaired the results of that particular shortcut more than once, and the glass always costs more than the roller job would have. High-tension and glass work is where a trained professional earns their keep. If your Mr-Glass door is binding, sagging, or leaking, call (561) 264-1279 and we will send a background-checked, uniformed technician to measure it properly and give you a written number.
FAQs
A properly installed Mr-Glass door in West Palm Beach should give you 15 to 25 years of service, with roller and sweep replacements expected every 7 to 10 years due to salt air and UV exposure wearing the moving parts faster than the frame. The frame itself, especially aluminum, can last 30 years or more if it was set square at the original installation. Call (561) 264-1279 for an assessment of your specific door.
Yes, in most cases. Rollers, latches, sweeps, thresholds, and even failed insulated glass packs can all be replaced without removing the frame, and that is almost always the less expensive path. We only recommend full replacement when the frame is corroded, twisted, or out of square beyond shimming. Call (561) 264-1279 for a straight answer on whether your door is a repair or a replacement.
Most Mr-Glass roller, latch, and sweep work takes 1 to 2 hours on site. A full panel removal and re-square usually runs half a day, and a glass pack replacement is a one-day job, most of it waiting for the glass sealant to cure. Call (561) 264-1279 and we will give you a realistic time window before we arrive.
We stock common Mr-Glass rollers, latches, and sweeps for the series we see most in West Palm Beach, and for older models with discontinued hardware, we source the exact match from our local supplier network before the appointment, not after. If your door needs a part we do not have on hand, we will know it before we arrive and schedule accordingly. Call (561) 264-1279 to confirm your model and part availability.
Call TruePane for Your Mr-Glass Door Installation
If your Mr-Glass door is not sliding the way it should, or it is letting weather in, call us at (561) 264-1279. We have been serving West Palm Beach homeowners since 2008 through a craft tradition that started with Dale Kessler watching his father re-glaze storefront windows along Dixie Highway. Dale trained in building construction technology at Palm Beach State College and has spent decades measuring, setting, and sealing doors across Palm Beach County. He reads a rough opening the way some people read a room, quietly and without rushing to conclusions. And as he keeps saying on the job site, if it is not square, plumb, and sealed, it is not done. We stand behind the work, the warranty, and the price. A live person answers the phone 24 hours a day, 7 days a week. Call (561) 264-1279 for your free written estimate.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving West Palm Beach and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.