Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterTrusted Door Installation for West Palm Beach Homeowners
A door installation in West Palm Beach has to stand up to salt air, hurricane season, and a summer sun that warps cheap jambs by August. We’ve been setting doors in this climate since 2008, and the problems we fix most are doors that bind, sills that rot from humidity, and hinges that pull loose from frames the builder rushed. When homeowners call us about a new entry door, a French door, or a storm door, they usually want the same thing: an opening that swings true, seals tight, and stays square for decades. TruePane Windows & Doors handles the whole job, from tear-out to final trim, with both manufacturer warranty layers registered in writing before our truck leaves your driveway. Call (561) 264-1279 if the door you have now is fighting you.
What Our Door Installation Service Includes
Entry & Swing Doors
Your front door is the first thing you touch when you come home and the last thing you close at night. A properly set entry door seals out rain and humidity, resists forced entry, and doesn’t need a hip check to latch. We remove the old slab and frame, correct any rough-opening problems with shims and proper flashing, and set the new door so a nickel placed on the top edge stays put through the full swing arc. Most Affordable Door Installation in West Palm Beach, FL projects take one day, including trim and hardware.
Double & French Doors
Double doors fail when the opening shifts even a quarter inch: one panel drags on the header, the astragal gaps, and a draft starts working its way through your living room. French doors in coastal Florida also need sills and threshold flashing designed for wind-driven rain, not the inland hardware some installers use. We square both active and passive panels before anchoring, install adjustable sills where the slab permits, and set the meeting-stile gap so the doors close with one hand and seal evenly top to bottom. If your existing French doors are bowing or you see daylight between the panels, Dale Kessler’s rule applies: if the pane is not true, the job is not done.
Bifold & Folding Doors
Bifold and multi-panel folding doors open a wall of your house to the patio or pool, but the engineering load is substantial. A four-panel folding unit can weigh over 600 pounds, and the floor track and header have to carry that weight without sagging or binding. We install the structural header, align the track to within an eighth inch across the full span, and tune each panel’s pivot so the stack folds and unfolds without lifting or dragging. These are the installs where cutting corners shows up in six months as panels that won’t lock flat.
Pivot Doors
A pivot door turns on a hinge point set back from the jamb, which means the panel can be much heavier and wider than a standard hinge door, but the installation geometry leaves no room for error. The top and bottom pivot points have to be perfectly plumb or the door swings under its own momentum and slams against the frame. We measure the rough opening twice, shim the pivot plates level, and adjust the closer so the door glides to a stop instead of freewheeling. Pivot doors are a statement piece; the statement shouldn’t be a cracked jamb from a rushed install.
Storm Doors
A storm door on a West Palm Beach home takes a beating: afternoon squalls, salt spray, and a daily open-close cycle that tests every spring and closer. The two most common failures we see are torn hold-back hardware and frames that rust through because the weep holes were never drilled. We install storm doors with the correct reveal at the sweep so condensation drains instead of pooling, and we use corrosion-resistant hardware rated for coastal exposure. A storm door should be a shield, not a maintenance project you re-gasket every year.
Arched & Custom Doors
Arched openings and custom-shaped doors are where templating matters more than anything else. A radius that’s off by a half inch will leave a gap no amount of weatherstripping can hide. We template the actual opening with a physical pattern, have the door fabricated to that exact shape, then set the unit and trim it so the reveal is consistent around the entire arch. Custom doors in this climate also get a full flashing detail and a sill pan that directs water away from the threshold. We’ve built and hung arched doors for Mediterranean and Spanish Revival homes from Palm Beach Door Installation Shores to Greenacres, and we know where these openings normally fail.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service for Door Installation
We’re an authorized installer for more than a dozen manufacturer lines, and we quote them side by side on paper so you can see exactly what you’re paying for. That includes Andersen and Pella for full entry and patio door systems, Marvin for custom and architectural-grade units, and Milgard for vinyl and fiberglass lines that hold finish well in coastal air. If you’re in a wind-borne debris zone, we install PGT and CGI impact-rated doors and can walk you through the product approval documents your insurance company will ask for.
We also work with CWS, ES Windows, and ECO Window Systems for openings where the homeowner wants a specific look or a particular glass package. Whether you have a brand-new Jeld-Wen unit or an older door that’s giving you trouble, we can help. The brand matters less than the setting; a premium door installed crooked is still a crooked door.
Signs You Need Door Installation Right Now
- The door won’t latch without lifting or pulling. A misaligned strike plate usually means the frame has settled or the hinges are worn. Forcing the door closed every time is making the problem worse, and eventually the lock mechanism will fail.
- You can see daylight around the edges when the door is closed. That gap is where your air conditioning goes to die, and in West Palm Beach humidity, it’s also where mold starts on the jamb. A proper re-install with fresh weatherstripping and a corrected reveal fixes both.
- The door scrapes the floor or the frame in summer. Doors in South Florida expand and contract with humidity. If yours only binds in August, the original installer didn’t leave enough clearance. Resetting the door with the right reveal is a one-day job for us.
- The sill or threshold is soft, spongy, or showing rust stains. Rotted wood and rusted metal under the door mean water has been getting in for a while. Replacing just the sill rarely works; the whole door and rough opening usually need to come out and be rebuilt.
- The door glass is fogged between the panes. A failed seal on a door’s glass unit means the argon or krypton gas has escaped and moisture is inside. That glass package needs to be replaced, and while we’re in there, we’ll re-set the slab properly so the new glass sits square in the frame.
Our Door Installation Process - Step by Step
- 1
Measure and template, twice. We don’t trust the old opening or the old door; we take our own measurements with the trim off when possible, and for arched or shaped openings we build a physical template. This is the step that prevents most of what we get called in to fix.
- 2
Quote what you’re actually buying. We put the manufacturer lines side by side on paper: glass package, frame material, hardware, and warranty terms for each. You make the decision with the numbers in front of you, and the price we quote is the price on the bill.
- 3
Tear out the old unit and inspect the rough opening. Before any new door goes in, we pull the old frame and check for water damage, termite trails, or framing that’s moved. If the opening needs repair, we correct it before we anchor anything to it.
- 4
Set the new door plumb, square, and flashed. We shim the jamb straight, anchor it through the shims (not around them), install a sill pan and flashing that moves water away from the framing, and set the slab so the reveal is even all the way around.
- 5
Test everything and register the warranty. The door gets opened, closed, locked, and inspected from both sides. Then we register both manufacturer warranty layers in writing, durations stated, and leave you with a copy before the truck pulls away. If it’s not done right, the Done Right Promise means we make it right with no paperwork fights and no arguing.
How Much Does Door Installation Cost in West Palm Beach?
A straightforward Best Door Installation in West Palm Beach, FL typically runs $800 to $2,500 for labor, depending on the condition of the rough opening and whether we’re replacing a slab or the entire frame and trim package. Double or French door installs land between $1,500 and $4,000 in labor, with the higher end covering structural header work and stucco repair around the opening. A full-height pivot door is usually $2,500 to $5,000 for installation, since the pivot hardware has to be set with masonry anchors and the panel weighs a few hundred pounds. Custom arched doors start around $3,000 for install and go up with the shape and finish. The door unit itself is separate, and that varies widely by brand and glass package; impact-rated PGT or CGI doors are typically double the cost of standard units.
What affects the price more than anything is what we find when the old door comes out: rotted studs, undersized headers, or slab settlement all add correctives that a bargain installer might just cover up. The way to avoid overpaying is not to pick the cheapest bid; it’s to get a written line-item quote that spells out exactly what’s included. Our estimates are free, they itemize every step, and the price doesn’t change because we found what we already suspected. Call (561) 264-1279 and we’ll give you real numbers for your specific opening.
Door Installation Near West Palm Beach - Our Service Area
We install doors throughout Palm Beach County, from West Palm Beach and Palm Beach north to Palm Beach Gardens, Riviera Beach, and Lake Park, and west through Royal Palm Beach, Palm Springs, and Greenacres. We also serve Loxahatchee Groves and the barrier islands including Palm Beach Shores and North Palm Beach. For more on our work in nearby neighborhoods, visit our Door Installation in Westgate and Door Installation in Lake Park pages. If you’re not sure you’re in range, call and ask; a live person answers 24 hours a day.
Serving West Palm Beach, FL - Our Local Coverage Area
We’re based in our Door Installation in West Palm Beach area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
Frequently Asked Questions - Door Installation in West Palm Beach
Door installation means removing an old door and frame, preparing the rough opening, and setting a new door unit so it swings plumb, latches securely, and seals against weather. It includes shimming, anchoring, flashing, insulation, and finish trim. We perform complete tear-out-and-replace installs, not just slab swaps, so the door doesn’t inherit the previous installer’s mistakes.
A standard single entry door installation takes one day in most West Palm Beach homes. Double doors, pivot doors, and arched or custom units typically take one to two days depending on the framing work involved and the condition of the existing opening. We’ll tell you the timeline before we start, and we’ll be there when we say.
A typical single entry door install runs $800 to $2,500 in labor, while double doors, French doors, and pivot doors run higher based on their weight and the framing detail. The door unit cost is separate and depends on the brand, material, and whether you need impact-rated glass. We give line-item written quotes so you know the labor and the door price before you make any decision. Call (561) 264-1279 for an exact figure on your opening.
Yes. We’re an authorized installer for, PGT, CGI, and more. We install their door lines to the manufacturer’s specifications so the warranty stays fully intact, and we register both warranty layers in writing before we leave. If a door was installed by someone else and is now binding or leaking, we can re-set it or re-install it correctly.
If a door is broken, jammed, or the opening is unsecured, we can usually get a technician to you the same day. A live person answers our phones 24 hours a day, 7 days a week, so you’ll never sit on hold during a break-in or storm. We’ll secure the opening first, then order whatever materials are needed for the permanent fix.
Every job is backed by our Done Right Promise: if the installation isn’t right, we come back and make it right with no paperwork fights and no arguing. We also register both manufacturer warranty layers in writing, with the durations stated, before our truck leaves your driveway. That’s The Keystone Standard, and it applies to every install we do.
Clear the area around the door on both sides, about six feet out, so we have room for the old unit and the new one. Move anything fragile off nearby walls, since removing a frame can send vibrations through the surrounding wallboard. We’ll protect the floor and dispose of the old door and frame; you don’t need to have anything hauled off yourself. Call (561) 264-1279 with any questions about your specific setup.
Schedule Your Door Installation Service in West Palm Beach Today
If your door is binding, leaking, or just looks tired every time you pull into the driveway, we’ll give you a straight answer and a written quote. Dale Kessler and the TruePane team have been earning the right to stand behind our work since 2008. Call (561) 264-1279 for a free estimate, and we’ll be there when we say. Done right, the first time.
Written by Dale Kessler, Owner at TruePane Windows & Doors, serving West Palm Beach since 2008.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.